Skip to content

Chapter 19: Application of soft and hard kick waxes

Chapter 19: Application of soft and hard kick waxes

Our iconic V40 Blue Extra kick wax is well-known and part of a large series of waxes, each with specific attributes to provide the perfect kick in all kinds of conditions. In this article, we'll focus on different tips when applying soft and hard waxes.

The kick wax is important to provide a good grip when skiing diagonal technique. Our range of waxes, from the V05 Polar for extremely cold temperatures, to the VP70 for temperatures above freezing, ensures that you will have optimal skis regardless of the weather conditions.

We offer two complete ranges of kick waxes:

  • V line: Our iconic line for recreational skiing and training.
  • VP line: A range of kick wax for competition and training.

Learn how to apply kick wax:

Base application of base wax and kick wax

  1. Sand the grip zone with #120 grit paper (T0011 Combi sandpaper/wax cork) approximately 60-65 cm. Wipe off dirt and base residue with Fiberlene (T0150). We recommend sanding only in the tip-to-tail direction of the ski to prevent rounding off the side-edges. Sanding should always occur AFTER treatment of the glide zones to avoid getting glide wax/powder into the kick zone.
  2. Apply a thin layer of base wax (VG035 or VG030) in the kick zone.
  3. Iron (110°C to 80°C) and let the wax cool off for a few minutes.
  4. Apply a layer of V0030 Blue (or V0040 Blue Extra).
  5. Swiftly move the warm iron over the grip zone once more. This wax layer should melt on top of the base wax and not mix with it. Let cool off and cork out.
  6. Apply the wax of the day.

V line

VP line

Tips when applying hard kick waxes

(0°C/32°F and colder)

There are different types of grip wax available in the market, which have different consistencies depending on the snow temperature. Hard waxes like VP30-VP50 and V0005-V0045 are suitable for colder temperatures and are easier to apply as compared to softer, warmer waxes like VP55-VP70 and V0050-V0060. However, by following some useful tips, even applying soft waxes can also be effortless.

  • For optimal results, consider building up the layers of wax like a pyramid. Start with longer layers and gradually shorten them until the shortest layer is under your foot.
  • It's best to apply several thin layers of wax instead of a few thick layers to achieve the best results.
  • When corking in the hard wax, avoid applying too much pressure. Leaving some texture in the wax will enhance the performance of your kick wax.
  • It's recommended to apply the initial layers of wax indoors, but it's best to apply the final layers of wax outdoors. Allow your skis to adjust to the outdoor temperature before testing them out.

Tips when applying soft kick waxes

(0°C/32°F and warmer)

To start, apply the base wax as previously described. Alternatively, you can use Base Klister spray KB20C in place of steps 2 and 3. When applying the wax layers, try to make them as thin as possible. Softer kick waxes will naturally require thicker layers than harder waxes, so it is normal to apply fewer layers of soft waxes.

  • For easier application of soft wax, cool it in the fridge or snow before applying it outside.
  • New corks are best for corking out soft waxes. Avoid applying too much pressure, or you risk the wax becoming like chewing gum. Use light pressure and more strokes.
  • Cork the wax to an even layer to avoid icing up.
  • Angling the wax against the base makes application easier.